Maintenance of the chassis. How to protect the machine from corrosion?

The problem of rust on the chassis of the car most often occurs in winter. However, now, when summer is gradually changing into autumn, the best time to apply corrosion protection. The whole operation is not extremely complicated or time-consuming, and most importantly, it significantly extends the service life of the sheets. In the following post, you will learn how to protect your car's chassis from rust in a few easy steps.

What will you learn from this post?

• How to protect the car chassis from rusting?

TL, д-

The chassis of a car is extremely susceptible to corrosion. However, due to the systematic inspection and care of this element, its service life can be increased. This is not difficult - first you need to thoroughly clean the suspension, and then evenly apply a special anti-corrosion agent. This operation is best done outdoors and at high temperatures, using a pressure washer and undercarriage sprayer.

Corrosion is the great enemy of the chassis

In winter, a car's chassis is especially prone to wear - the combination of gravel and road salt and adverse weather conditions is a destructive mixture for metal. Factory underbody protection is not always 100% effective.Therefore, it is worthwhile to check the condition of this element of the vehicle from time to time and, if rust is found (or just for prevention), carry out maintenance yourself.

You will have to get used to the idea that corrosion cannot be avoided - you can only slow down its development. The sheeting alone does not provide eternal protection, so every few years it is worth checking to see if it needs to be supplemented. Degradation progresses much faster in vehicles that often drive over rough terrain such as gravel or sandy surfaces.

Chassis maintenance - do it yourself

Preparing the chassis

First, the chassis must be thoroughly cleaned and degreased. - it is best to do this outdoors and at a temperature above 20 degrees Celsius. Get a pressure washer, wet the entire element and clean it thoroughly. Then wash the case again, this time in water mixed with detergent (dishwashing liquid, for example) - this will allow you to get rid of grease stains.

If there is already rust on the chassis of your vehicle, remove it with a wire mesh. - this is a rather tedious job that should be done carefully, because in places previously corroded, the newly applied protective layer will adhere to the metal surface. After washing, the car must dry out - sometimes it takes a whole day.

Protective coating

It's time to apply a protective layer. In this role, the so-called lamb. You can apply it with a coarse-bristled brush, but the best solution is to use a dedicated adjustable-width spray gun. The coating should be evenly distributed and approximately 2 mm thick. Let the substance dry and set for 8-10 hours before starting the vehicle.

Also remember to never apply the drug to moving parts of the chassis or exhaust system. – under the influence of the high temperature created by the engine, it can burn for the next several weeks, emitting an unpleasant smell. If you accidentally stain these components, clean them thoroughly with a cloth dampened with gasoline.

Properly performed chassis maintenance will prolong the life of your vehicle. It's not just a matter of future insurance, but simple math - the cost of a suspension upgrade every few years is much lower than the cost of sheet metal repairs from a locksmith - so you're protecting not only your car, but also your wallet. . If you are looking for undercarriage cleaners or other useful car accessories, visit the avtotachki.com online store. We offer the highest quality products from renowned manufacturers.

You can read more about car maintenance here:

How do I wash my engine to avoid damaging it?

Does frequent car wash damage the paintwork?

Clay - take care of your body!